410A Pressures On A 80 Degree Day. The discharge pressure at this operating conditions hovers around 400 psig. Accordingly, what is suction and discharge pressure of r410a?
Charging a Heat Pump at Start up or in the Winter Time from www.youtube.com
This script determines the gas pressure based on temperature of r410a refrigerant. Energy efficiency is comparable to r22. Ensure the thermometer makes adequate contact and is insulated.
For Best Results, Temporarily Install A Thermometer On The Suction Line Near The Compressor.
Its benefits include significantly higher cooling capacities and pressures. I felt like 475psi on a 80 degree outdoor temp was really high. This script determines the gas pressure based on temperature of r410a refrigerant.
The Discharge Pressure At This Operating Conditions Hovers Around 400 Psig.
I installed a 410a, 2 ton condenser and coil today. So, we’re looking at a head pressure of 225 psi, a suction pressure of 75 psi, liquid line temp @ 100f and suction line temp @ 55f. Accordingly, what is suction and discharge pressure of r410a?
It Depends On The Inside Air Temperature For The Suction But Typically If Its75 Degrees Farenheight Inside The Suction Should Be120 Psig Unless You Have A Tev Metering Device Wich Typically Causes The Suction To Run Lower Than A Fixed Orifice Metering Device.
It has ran great for about 2 months. Energy efficiency is comparable to r22. Systems operating on r410a run at a pressure of about 1.6 times that of similar systems operating on r22.
Furthermore, R410A Is An Hfc And Is Commonly Used In Residential And Light Commercial Hvac Equipment For Air Conditioners And Heat Pump Systems.
The discharge pressure at this operating conditions hovers around 400 psig. R410a is an hfc refrigerant, invented by honeywell, that has been developed to replace the hcfc refrigerant r22. What should the high and low side pressures be?
Immediately It Began To Cool And The Low Side Began To Be Super Cold And Sweat From The 80 Degree Outside Temperature.
The low side was 120 with 10 degree super heat, just like the manufacturer recommendations, but the high side was 475psi with 40 degree of subcooling. The thermometer should be located within 4” to 6” of the compressor. If the outdoor ambient is below 95°f optimally you should not feel any significant temperature rise above your hand temperature (97°).
