Ipoint Orbit Pencil Sharpener Not Working. Place piece #5 on top of the center cylinder in piece #3. First i unplugged it and removed the outer plastic shavings catcher.
Westcott iPoint Orbit Electric Pencil SharpenerBlack from www.walmart.com
If the unit does not operate when a pencil is inserted into the hole, make sure power is on at the outlet, then test the electrical cord and replace if faulty. This pencil sharpener is the holy grail of sharpeners. Remove the 4 screws as shown in figure 4.
Something Came Out, But Not The Entire Broken Bit So Finally I Poked Around With Tweezers Or Something Else Similarly Small And Pointy And That Did The Trick.
First i unplugged it and removed the outer plastic shavings catcher. Dump out the shavings and replace the lid. It works on every single brand i own (which is a lot) including fatter derwent pencils and hexagonal albrect durer.
If Your Pencil Sharpener Will Not Sharpen The Pencil Well, Check That The Space Where The Pencil Tip Should Go Is Not Blocked By Broken Graphite (The Black Part) From The Tip Of The Pencil.
Westcott pencil sharpeners are necessary for any school or office that uses pencils regularly. Using your screwdriver, unscrew each of the screws holding the bottom plate of the sharpener on. Empty the ipoint once the shavings inside of the shavings reservoir reach midway.
Remove The 4 Screws As Shown In Figure 4.
A good pencil sharpener will keep your writing instrument sharp and ready to use for a long time. Hold the base of the sharpener in one hand, and twist the reservoir cap counterclockwise until it comes off. Electric pencil sharpener with auto stop feature to ensure no over sharpening.
Insert The Sharpener Into The Reservoir Cap Before Use.
Westcott ipoint orbit electric pencil sharpener, black (16059) sku. Proprietary titanium bonded blade technology keeps blades sharper longer. If the unit still does not operate, the problem could be in the motor.
How Can I Identify An Electric Pencil Sharpener Problem?
This is the only sharpener that has completely fixed the lead. Place piece #4 into piece #3. If you don’t see any, use a knife to gently pry up the foot pads.
