2004 Pontiac Sunfire Fuel Pump. Problem was in main wiring harness plug at driver side kic. Save up to 40% on original replacement 2004 pontiac sunfire fuel pump relays.
Fuel Pump Module Assembly For Cavalier Malibu Grand Am from www.ebay.com
The fuel pump should be connected through a fuse in slot 48. Not getting up to speed when i press down on pedal, not starting right away, feeling jerky while driving ) i was told back when i replaced the. Pontiac sunfire with plastic fuel tank 2004, fuel pump module assembly by tyc®.
The Fuel Pump Will Be Located Inside The Fuel Tank As Part Of The Sending Unit Assembly, But You Can Replace Just The Fuel Pump, Instead Of The Sending Unit Assembly If You Choose To, Ideally Its Better To Get The Sending Unit With The Fuel Pump, That Way All Is Good And.
Had an obd p0172 code and i replaced the upstream o2 sensor. If that fuse looks good, then you may want to check the fuel pump relay (also inside the engine compartment fuse box). My issue is crank no start no power to the fuel pump.
Buy A 2004 Pontiac Sunfire Fuel Pump Wiring Harness At Discount Prices.
The average price of a 2004 pontiac sunfire fuel pump replacement can vary depending on location. No customs, no duties, no hassles Pontiac sunfire fuel pressure regulator.
Order Online At Buyautoparts.com And Get Your Parts Tomorrow.
100% factory tested for leakage and dimensional precision. Includes fuel pump, sending unit, float, fuel reservoir, fuel strainer, upgraded wiring harness and tank seal The fuel pump should be connected through a fuse in slot 48.
The One That I Put In Only Clicks When You Turn The Key And Will Not Run.
Check if this fits your pontiac sunfire. Testing the pump and pressure on each side of it are going to be the quickest ways to rule it out. 2004 pontiac sunfire se 4 cyl 2.2l.
Start With The Car Off, And Have Somebody Else Put The Key In The Cars Ignition.
About a year ago my car stalled and i had to replace the fuel pump. Save up to 40% on original replacement 2004 pontiac sunfire fuel pump relays. I established the control side of the circuit was good and that the supply power back to pump was good.
