Engine Hot Ac Off 2008 Impala. Use a scan tool to clear the codes. The engine has an “engine hot ac off” light.
Check Engine Light Chevy Impala 2009 from americanwarmoms.org
After replacing a thermostat you need to wait till the thermostat opens and re add more coolant till its full. We have changed the thermostat coolant sensor the thermostat, and the connector, i am still getting the same message. If the ac is operational, when you turn it on, the radiator fan should come on telling you the fan motor is ok.
When The 2009 Chevrolet Colorado Displays The “Ac Off”, It Means That The Engine Temperature Is To High And You Need To Shut Off The Air Conditioner In Order To Help Let The Engine Cool Down.
You still may have an issue with a fan control related to temperature. Remove the clamp which locks in the radiator. It is in 30's here, car has 169000k on it.
2008 Chevy Impala Ltz Intermittent Problem Ac.
26 people found this helpful. She brought the car in to have the diagnostic done, and got a po128 code. This would show if the thermostat is ok.
I’ve Already Replaced The Thermostat, Coolant Sensor & Sensor Connector.
It seems to reset itself after a while. If the engine doesn't maintain specific temp parameters (doesn't warm up fast enough/maintain temp), this warning will display. I just had a car starter installed, and i started getting the engine hot/ ac off message.when put on scanner, code p0116 come on.
Flushed The Radiator & Refilled With Dexcool.
I have a 2008 1500 4x4 4.3 v6 with 40000miles. The engine hot/ac turned off light came on and. The contact stated that after starting the vehicle, there was an abnormal noise coming from the vehicle and the a/c failed to function.
I Replace The Thermostat The Old One Was Bad But It Still Says Engine Hot Ac Off With The Engine Light On.
By the time you can tell it's warmer than usual, it's almost certainly done. The 2009 chevrolet impala has 1 problems reported for engine hot, turn ac off warning. We have changed the thermostat coolant sensor the thermostat, and the connector, i am still getting the same message.
