Hoover Spinscrub Not Picking Up Water. After the first dirty water dump it stopped sucking because the yellow float “ball” would immediately go up and stop the flow. Hoover h3030 floormate spinscrub 500 upright wet/dry vacuum first make
Hoover Spinscrub Carpet Cleaner Manual from bigwhiskeygrill.com
Check your filters and make sure all of the doors and latches are properly closed so that the machine can achieve a good suction. If the machine simply won't start and just clicks when it is plugged in and turned on, it could be that the automatic shut off has been inadvertently activated. There is a water/cleaning solution tank as well as a wastewater tank so the two don’t mix.
Lift The Tank Off And Pour The Water Down The Drain.
Check the recovery tank and empty it if it is full. Try to rinse out the water tank, including the foam filter, and also rinse out the nozzle as it may have clogs in it. My spinbrush 50 worked fine for about 5 minutes out of the box.
If The Cleaner Is Still Not Picking Up Water, You May Have To Rinse Out The Various Parts With Water Before Continuing.
My carpet cleaner will not pick up any water at all, it sprays th.e cleaner out just fine but will not suck up the dirty water. Tighten the filter lid if it is askew. Re fit the empty tank and resume cleaning.
If The Water Tank Is Full, You’ll Hear A Change In Pitch And The Yellow Disk Inside The Tank Will Shoot To The Top Which Means The Cleaner Will Not Pick Up Anymore Water.
I have a hoover steam vac dual turbo power carpet cleaner with. This will unlock it from the machine. After the first dirty water dump it stopped sucking because the yellow float “ball” would immediately go up and stop the flow.
The Power Scrub Will Not Pick Up Water Even Though The Power Is On.
The hoover spinscrub 50 has a pair of water tanks. Just press the gray button (it’s on the handle) and lift it up. Turn the cleaner off and unplug the machine.
Lift The Tank Off And Pour The Water Down The Drain.
Make sure that the cap is secure on the tank when you replace it. Fill the cleaner tank with water and sit it on a hard floor, not a carpeted area. Lack of suck solutions if it is not sucking up water properly, make sure the dial is set to floor cleaning.
